cozmicray wrote:They are from ATI
M8s at least the best nut to fit them is a M8 nut
I have set mm/step to all kinds of different settings
tested my ATI OrdBot Hadron with digital depth guage
Looks like 2570 is the setting for my printer
I have results in a spreadsheet and can do them again
See viewtopic.php?f=33&t=1578
I just noticed on a failed print
Air shots ( squirt out of PLA from above nothing) the diameter 0.50 - 0.55 mm
shouldn't it be closer to 0.4mm?
Tnx
roberlin wrote:The 1.25 refers to the nominal pitch of standard M8 threads.
i.e. if you turn the nut 1 revolution it is supposed to move 1.25mm along the rod.
In any case, 2570 vs 2560 will not make a radical difference in your prints.
It is less than half a percent.
Getting your flow off by 10% even will not make a print truly "cruddy".
Users browsing this forum: No registered users and 44 guests