bdring wrote:3. Again this compares to the original design and the other versions of folded brackets and printed brackets. Currently the Z motor is as close to the Misumi extrusion as possible. With the folded u channel, the motor can move a lot closer to the Z extrusions which has many benefits in any design.
Could you elaborate on the benefits of moving the motor closer to the Z extrusions?
You get this alignement concern because you chosed flat nuts in your ORD Bot BOM.bdring wrote:2. You still have the alignment in the X direction because you are mounting to t-slots.
How many millimeters did you shift the motors closer?bdring wrote:3. With the folded u channel, the motor can move a lot closer to the Z extrusions which has many benefits in any design.
bdring wrote: If you try to put it behind the gantry plates, the increased wheel spacing hurts stiffness.
Users browsing this forum: No registered users and 10 guests