SystemsGuy wrote:Here ya go - Roy 's changed the layout of his drivers between the two versions. Easiest way its to check the pinout. Which brings up another point - I have this awesome X3, but no decent documentation to speak of - does ANYONE have a schematic?!?!?!
Bonus points for a schematic for the expansion boards.
cozmicray wrote:This might help
Reprap site
http://reprap.org/wiki/Azteeg_X3
or the panucatt site
http://panucatt.com/Azteeg_X3_reprap_3d ... ax33dp.htm
albill wrote:Of course, then I look at the Bukobot assembly page for the X3, and they have the steppers in the opposite direction. WTH?
Though the text is oriented the same so maybe they just have the screw for tuning the pots in a different location?
Users browsing this forum: No registered users and 33 guests