; layer_height = 0.25
; perimeters = 2
; top_solid_layers = 0
; bottom_solid_layers = 2
; fill_density = 0.0
; perimeter_speed = 40
; infill_speed = 60
; travel_speed = 180
; scale = 1
; nozzle_diameter = 0.35
; filament_diameter = 1.75
; extrusion_multiplier = 0.8 (depending on your extruder calibration)
additionally with a Brim of 3mm
Temperature (PLA): 200 degrees C
syldcru wrote:I printed the test square (TestCube.stl) and here is the result. What was the size of the square?
flurin wrote:Which Firmware are you using?
Try Repetier-Host, anyway a better solution.
http://www.repetier.com/
gyrogearloose wrote:flurin wrote:Which Firmware are you using?
Try Repetier-Host, anyway a better solution.
http://www.repetier.com/
I have to agree. Repetier-Host is way better. It allows you to change the print speed and extrusion rate on the fly while you are printing. Pronterface cannot do this. Besides, Pronterface is an annoyingly stupid name anyway.
Users browsing this forum: Majestic-12 [Bot] and 14 guests