Wiring the heat bed?

Topics Related to the ORD Bot Printer

Wiring the heat bed?

Postby bjoerngiesler » Sun Aug 18, 2013 12:28 am

Hi all,

after buying a drill press, I'm in the process of re-wiring my Hadron with springs and all, to make it as pretty as the pictures. Before it looked like a rat's nest...

Unfortunately, exactly wiring what where isn't so well documented. I've figured out how to wire the axes and the extruder(s) from the pictures (X and Z through the base, Y and extruder using springs). What I haven't figured out yet is how to wire the heat bed. Another spring? But where from? Any advice on that?

Any help is appreciated.

Regards,
Björn
bjoerngiesler
 
Posts: 33
Joined: Tue Feb 14, 2012 3:28 pm

Re: Wiring the heat bed?

Postby regressedEE » Mon Aug 19, 2013 4:01 pm

Björn, if you look at page 2 of the high-level diagram (PDF here), the hole at the bottom of the left-side (from the rear) upright is where the spring for the heated bed wiring goes.
regressedEE
 
Posts: 25
Joined: Sat Oct 13, 2012 2:33 pm


Return to ORD Bot

Who is online

Users browsing this forum: No registered users and 3 guests

cron