cvoinescu wrote:That is not the latest design. The latest has two pieces, one threaded and with a long arm that slides in the T-slot of the vertical MakerSlide, and one with a larger hole that is attached to the gantry. The gantry simply rests on the nut.
The vertical play is of no consequence -- gravity gives you enough preload to avoid backlash from that.
cvoinescu wrote:http://www.buildlog.net/forum/viewtopic.php?f=33&t=1830&p=16863#p16863
http://www.buildlog.net/documents/b17060-L_rev_1.pdf
http://www.buildlog.net/documents/b17060-R_rev_1.pdf
http://www.buildlog.net/documents/b17061_rev_1.pdf
Bart has updated the BOM with the new parts.
cvoinescu wrote:Sorry for the silly question, but after you changed that line, did you compile the firmware and upload it to the controller?
flickerfly wrote:Great job jammer. Congrats on your early success.
Users browsing this forum: No registered users and 24 guests