DSP Conversion

Discussions and help on this commercial controller.

Moderator: twehr

DSP Conversion

Postby redpiperbob » Thu Nov 05, 2015 6:26 am

Hi All
I hope someone out there can help me please.
I am building a laser cutter/engraver based on the Bdring model with maker slides and v slot rollers.
I have had this working with
New DSP CO2 Laser Cutter Engraver Machine LCD Motion Controller System PH3
http://www.ebay.co.uk/itm/231078944368? ... EBIDX%3AIT


I am trying to set up this board but I am not having much luck.
If I switch on the machine the x and the y axis go to the home postion fine.
but if I try to move the zxis with the arrow buttons on the machine or the software I somtimes get a jerk then nothing.or I get no movement at all.
I am trying to setup the parameters but with no luck I came across this page

http://www.buildlog.net/wiki/doku.php?i ... controller


but the file that is mentioned there will not load into the progamme.
Can anyone help please.

Bob
redpiperbob
 
Posts: 3
Joined: Tue Sep 20, 2011 7:18 am

Re: DSP Conversion

Postby sshwarts » Thu Nov 05, 2015 2:17 pm

Hi. If you can give a little more information. Currently what are your setup parameters? I'm presuming that you can read them from the PC application and maybe share a screen shot?

Scott
sshwarts
 
Posts: 93
Joined: Tue Apr 22, 2014 6:37 pm

Re: DSP Conversion

Postby redpiperbob » Fri Nov 06, 2015 7:09 am

Hi Scott thanks for repling
Here are a couple of shots of the settings in PHcad
Image]
That is the contol parameters

Image
that is the manufactuers parameters
My machine is running on GT£ belts and pullies here is an overall picture of it.
Image
Hope you can help
Thanks
Bob
redpiperbob
 
Posts: 3
Joined: Tue Sep 20, 2011 7:18 am

Re: DSP Conversion

Postby redpiperbob » Sat Nov 07, 2015 11:59 am

Hi There All
Thanks for the help found out how to do it
thanks RSM5178

thanks
Bob
redpiperbob
 
Posts: 3
Joined: Tue Sep 20, 2011 7:18 am


Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 0 guests

cron