Troubleshooting

Questions, Suggestions, Tips, Etc

Re: Troubleshooting

Postby bloq » Sun Jan 24, 2016 5:36 pm

Hey,
thank you very much! 1/128 should give just about 1 um /pulse with my setting which should work for the x7. But 200 mm / s is not very fast ;-)
I hope i can live with that. One thing that is really strange: My engravings are pretty good without any problems but the cutting is that bad. I
will give it a try. Which drivers did you buy? i currently use the m415c

thanks again,

tm
P.S: Kees has the ultimate laser machine ; )
bloq
 
Posts: 88
Joined: Mon Dec 29, 2014 9:15 am

Re: Troubleshooting

Postby rsm5178 » Mon Jan 25, 2016 11:06 am

I bought leadshine dm442c drivers cheap on ebay. It's closer to the 150mm/s. Wood was alway decent with engraving. Anodized aluminum is now very crisp at a smaller font.

To gicve you an estimate, A cutting board with a 7"x7" engraving took 40 minutes. (Estimating on size since I no longer have it.)

I'm sure you could go with a lower resolution and still be satisfactory quality wit a ltitle higher speed. I just haven't played with that yet.

All depends on what you're looking for in your laser.

Rich
Attachments
20151230_185836.jpg
rsm5178
 
Posts: 119
Joined: Tue Jul 23, 2013 9:57 pm
Location: 19425

Previous

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 2 guests