by edmond22 » Sat Apr 30, 2011 8:31 pm
Got 3 stepper motors today, they are all single shaft though the guy had a few double shafted ones but they were a different make and specs they also had a MXL timing pulley on one side and a flywheel/resonance damper on the other side the only specs they had on them was 6.2 ohms. I might get 2 of the double shaft and another single shaft one, maybe I can make the double shaft one work otherwise i will just use 2 motors on the y axis and slave them in Mach 3, but then I need a 4 axis stepper driver.
The specs on the 3 motors I got are as follows:
2.6V
1.2A
1.8 degree step angle
44oz/in holding torque
6 wire
They also came with 20 tooth MXL timing pulleys on them a real bonus, I hope they work and that the torque isn't too low.
- Attachments
-
- stepper motors