Vertical - These channels will be open, Install t-nuts as needed
awesomenesser wrote:I forgot that you need a single t-nut in 1c and 1d on the inside. I have updated the sheet.
awesomenesser wrote:Here are the proposed changes and my fixes:
- What are these for? The system model does not include anything attached to those loose t-nuts? I have not made this change yet.
- 1a top = 2 loose (4 total)
- I was wrong but shouldn't it be 1 loose [2 total] - Changed to 1 loose [2 total]
- 3a left/front = 1 loose (1 total) (on the other end of the frame it attaches on top, not on front)
Users browsing this forum: No registered users and 0 guests