BenJackson wrote:I've pushed my git repo to github
I'm sure it's incomplete, so please ask questions and I will improve it.
Well, I'm still fighting with my power supply issue and I haven't tried rastering yet but otherwise I've have great success with your config. I only had one small struggle: I'm generating my g-code from HeeksCNC with the emc2b simplified post-processor. When I'd run the g-code through your config, EMC2 would appear to lock up for a long time and then be incredibly sluggish when it came back. I finally realized that it's because your config has the manual tool change hal component disabled and Heeks was putting in an M6.
HeeksCNC uses the tool diameter to account for the kerf when calculating the tool path and the profile operations are configured to cut on one side of the line or the other (or on the line if you choose). Without tools, are you using EMC2 cutter compensation or accounting for the kerf in your design?
Very nice work, btw. Thanks again.