Using a ShuttlePro as a Laser Pendant
I have been using a ShuttlePro as a pendant for years on my router. A pendant is basically a hand held remote control for your CNC. It allows you to control a set of functions right at the machine. I typically use it to zero the machine on the part, tweak the feedrate, start/pause/restart the job and do an e-stop.
The router’s pendant is starting to die. It has been through hell. I have dropped it about 10 times on the concrete floor. It has also seen a lot of oil and fine dust. A couple buttons are getting intermittent. I have the functions to working buttons, but I was getting worried it would stop working completely. I could not live without it, so wanted to get a replacement on order. I found a good deal on eBay ($54) and since they had several, I decided to get one for the laser as well.
The ShuttlePro was designed for video editing. One thing you do a lot in video editing is jogging the video forward and backward. Typically you want to race forward until you get close then slow down and even go frame by frame until you get to the desired spot. Sounds like CNC doesn’t it? It has three dedicated functions for this. Full speed forward and back via buttons, variable speed via a spring loaded jog dial and a frame by frame little detented rotator wheel. It also has a lot of redefinable buttons. These buttons have clear snap on caps, so you can add labels to them. I have a Corel and PDF template at the end of the post. Someone at the Mach3 forum dicovered this product and within days there was a plugin for it.
Setting it up is easy.
Download the ShuttlePro plugin from the Mach3 downloads page. Place the ShuttlePro.m3p file you download in a convenient place like your desktop. Double click on it. That will launch a program that registers it with Mach3. Plug in the ShuttlePro into your computer. It uses the built in Human Interface Driverss (HID) so you do not need to install a driver. It comes with some software to test it, but you must uninstall it before using Mach3. Start Mach3.
Use the config Plugins menu pick to open the
Make sure the plugin is enabled with a green check. Now click on the word config to the right of the plugin name.
That will bring up the screen above. Each button can be associated with any of many functions. My config is shown above. You probably want some keys across the top to select the current axis. I like to have the two buttons to the outside of the central wheels be rapid movement buttons. It is also handy to be able to lock the pendant so accidental button pushes do not screw up a run. I used the second button from the lower right. The rest are up to you and how you use your laser.
Below is a video demonstration on my laser.
BTW: The Pololu version 1 board in controlling the laser here.
Just saw this. Havn’t heard the shuttlepro mentioned before. Have a bid on one now thanks 🙂
Thank you so much for sharing – I bought one and use it with my Syil machine. Could you upload the pdf/corel draw template that you used? I just copied the same settings as you had – it worked for me very nicely!
Again – many thanks for posting, I would not know about Shuttle Pro otherwise.