TLHarrell wrote:I've read that using Fast Orange is great on wood. I haven't found it in a store yet but I'm still looking.
BenJackson wrote:One trick I heard was to use water soluble PVA Mold Release. You can smear it on any kind of plastic before engraving and engrave right through it and after you can wipe it off with a wet cloth. It keeps the white film from condensing on the acrylic (or whatever you're engraving).
Tap plastics sells it. I actually have some (based on the recommendation of the above trick) but I have not tried it. My 2.x laser still isn't set up for engraving (the perils of being a DIY'er -- perhaps I should just buy the damn DSP...)
Return to Air Assist/Vacuum/Fume Extraction
Users browsing this forum: No registered users and 5 guests