Router Bits
Posted:
Mon Apr 05, 2010 5:18 pm
by bdring
This is a great place to get very small router bits. Good prices too.
http://www.precisebits.com
Re: Router Bits
Posted:
Sun Apr 11, 2010 5:12 am
by Ben
I have quite a collection of bits from
http://american-carbide.com They have a modest selection and their prices are very reasonable.
Re: Router Bits
Posted:
Tue Jun 29, 2010 3:26 am
by lasersafe1
Spiral-O-Cut bits for Acryilics, and others for aluminum. I am purchasing the Aluminum to try. They sure look fancy..
http://www.toolstoday.com/p-5879-solid-carbide-spiral-plastic-o-flute-up-cut-down-cut.aspx
Re: Router Bits
Posted:
Fri Jul 23, 2010 12:46 am
by lasersafe1
I bought a couple for aluminum machining. They were $22 each. At the same time I purchased a similar single flute aluminum cutting bit in a quantity of 10 for $21 on ebay. The bits from ebay actually out-performed the bits costing ten times more. I also ordered a few bits from precise bits. For my purpose (aluminum), nothing beats the ebay deal.
Here is the bit:
http://cgi.ebay.com/10-x-1-8-Carbide-CNC-Router-Bits-Single-Flute-Tools-/130386839110?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item1e5ba94646The ebay store is SUPERWORKSHOP-BITBITWORLD
Re: Router Bits
Posted:
Fri Jul 23, 2010 1:57 am
by bdring
Yes, the precise bits are not made for aluminum, but they did work for me. I started buying from them for PCB isolation routing. I have a 0.010" end mill for that.
Single flute is best for aluminum if you have a high speed spindle, like most of us wood router people use. Otherwise, the aluminum just gets gummy....no decent chips.
That is a great eBay price by the way and I am glad to hear you recommend then.