Hot water trick for PLA

General discussion of 3D printers

Hot water trick for PLA

Postby mxk » Sun Feb 05, 2012 4:34 pm

I've read many times on the reprapwiki about people using a heat gun or hot water to soften PLA bushings for their Prusa, but since I have a different model (Sells Mendel) I usually move on by.

My prints for bearings or captive nuts usually are very tight, enough that I usually must sand them lightly for the part to fit. Today I remembered the hot water trick, and popped an extruder idler into a cup of boiling water for a few seconds. It softened up enough for me to press-fit the bearing into place, and a few second later it was rock hard again, with a captive bearing and no plastic dust!
mxk
 
Posts: 123
Joined: Wed Jun 08, 2011 11:02 pm

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 6 guests

cron