Host Software - 2nd Generation

General discussion of 3D printers

Re: Host Software - 2nd Generation

Postby flurin » Mon Sep 17, 2012 2:46 pm

My latest SW:

Repetier-Host Mac 0.32
Slic3r 0.9.2
Marlin RC2 1.0.0

I'm not using Repetier-Firmware just now because I didn't see any advantages compared with Marlin. But this may change in the future.
User avatar
flurin
 
Posts: 203
Joined: Mon Feb 27, 2012 12:09 pm
Location: Switzerland

Re: Host Software - 2nd Generation

Postby dzach » Fri Sep 21, 2012 8:48 pm

I use Repetier-Host regularly. I installed Repetier-Firmware but my clone - Arduino Mega 2560 part of RAMPS died before I could test it thoroughly and the Mega1280 replacement I had did not run Repetier-Firmware for some reason.
Now that I received another clone Mega2560 I will try it again. The firmware I have now installed in RAMPS is Sprinter.
dzach
 
Posts: 180
Joined: Sun Feb 19, 2012 12:47 am
Location: Athens, Greece

Previous

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron