What are the hot end options?

General discussion of 3D printers

What are the hot end options?

Postby gavztheouch » Sun Sep 16, 2012 5:02 pm

Currently what is best hot end to use with any 3d printer, I like the look of the Ubis Hot End as used on the printr bot. Any other good options out there or one to avoid.
Timothy hay for rabbits delivered over the UK http://www.timothyhay.co.uk
gavztheouch
 
Posts: 144
Joined: Sun Dec 12, 2010 11:08 am
Location: (Stirling) UK

Re: What are the hot end options?

Postby Enraged » Sun Sep 16, 2012 6:07 pm

many options depending on your budget.

Right now I've got a J head hot end with a Wades Reloaded extruder, but I'm changing to a QU-BD extruder once it gets here.
Enraged
 
Posts: 439
Joined: Fri May 06, 2011 3:13 pm

Re: What are the hot end options?

Postby cozmicray » Fri Sep 21, 2012 5:56 pm

I am just building first printer -- OrdBot Hadron
I got a mBot Mk 7 extruder
http://www.mbot3d.com/collections/toolh ... p-printers

I turned it 90 deg to fit on the bracket better,
that required drilling a new hole on the steel mounting plate.
Also drilled the Hadron plate to accept mounting holes on Mk 7

It comes with a driver board - that I will not need with RAMPS electronics.
I do wish there was some type of safety cut off electronics for overtemp.

I'll let you know how it works when I get it squirting hot plastic.

Keep on buildin'
Ray
cozmicray
 
Posts: 168
Joined: Thu Sep 20, 2012 4:32 pm
Location: Blue Bell, PA


Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests

cron