What are the hot end options?

[gavztheouch]

Currently what is best hot end to use with any 3d printer, I like the look of the Ubis Hot End as used on the printr bot. Any other good options out there or one to avoid.

[Enraged]

many options depending on your budget.

Right now I've got a J head hot end with a Wades Reloaded extruder, but I'm changing to a QU-BD extruder once it gets here.

[cozmicray]

I am just building first printer -- OrdBot Hadron
I got a mBot Mk 7 extruder
http://www.mbot3d.com/collections/toolh ... p-printers

I turned it 90 deg to fit on the bracket better,
that required drilling a new hole on the steel mounting plate.
Also drilled the Hadron plate to accept mounting holes on Mk 7

It comes with a driver board - that I will not need with RAMPS electronics.
I do wish there was some type of safety cut off electronics for overtemp.

I'll let you know how it works when I get it squirting hot plastic.

Keep on buildin'
Ray