RAMPS1.4 on Ordbot Hadron troubles
Posted: Fri Oct 05, 2012 12:00 am
I have built up an Ordbot Hadron.
I have a RAMPS1.4 shield on a ATMEGA 2560
RAMPS from GADGETS 3D.
I have run RAMPS test code and leds blink and heaters heat
Temperature pins respond to pot across them.
NO motor movement.
I hooked up a known good motor and no movement
Seems no signals to motors at all?
No pulse signals on scope hooked up to motor phases.
Any suggestions?
Tnx
I have a RAMPS1.4 shield on a ATMEGA 2560
RAMPS from GADGETS 3D.
I have run RAMPS test code and leds blink and heaters heat
Temperature pins respond to pot across them.
NO motor movement.
I hooked up a known good motor and no movement
Seems no signals to motors at all?
No pulse signals on scope hooked up to motor phases.
Any suggestions?
Tnx