Slic3r fill

General discussion of 3D printers

Slic3r fill

Postby cozmicray » Mon Nov 26, 2012 7:01 pm

My Slic3r v 0.9.5 has a problem.
What ever fill I choose ---- I get rectilinear

I wanted to use concentric but when selected doesn't use it

Is this a bug or a feature?

Posts: 168
Joined: Thu Sep 20, 2012 4:32 pm
Location: Blue Bell, PA

Re: Slic3r fill

Postby orcinus » Mon Nov 26, 2012 7:19 pm

If it's any version of Slic3r beyond 0.7.2, it's quite likely a bug :P

Seriously, there hasn't been a bug-free version since 0.7.2.
I occasionally install the new ones and play with them, but always end up going back to that. The new ones are way too unpredictable and wonky. About the only bug 0.7.2 has, besides useless overhang support generation (which counts as a "feature", i guess), is that it creates a free-standing "dot" outside sharp corners, which is detached from the actual object and easily removed after printing.
Posts: 720
Joined: Tue Feb 14, 2012 4:03 am

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest