Building a new extruder

General discussion of 3D printers

Building a new extruder

Postby REdington » Fri Dec 07, 2012 6:01 pm

My idea is to build a inclosed gearbox and mount it on the motor. Then make a extruder gear out of 1/2 inch steel rod (would make it out of 303 stainless if I had some here) with a 4-40 or a 6-32 gun tap. I think by going to a little larger diameter on the gear, I'll have more area for contact on the filament. I'll machine a mount out of alum the will hold the bearing against the filament that will be spring loaded.

The gearbox

Last winter I had to make some gears, so I while I had the mill setup, I made several different racks in 40 and 32 pitch and a few different teeth count.
Image
I'll use a 32 pitch gears with a 15 tooth gear on the motor and a 36 tooth gear on the out put shaft.
I'll post pictures as I build this and will start on it next week.
Rodney
REdington
 
Posts: 57
Joined: Wed Aug 29, 2012 4:14 am
Location: Leavenworth Ks

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron