Repetier Z Limit Sw Issue

General discussion of 3D printers

Re: Repetier Z Limit Sw Issue

Postby orcinus » Thu Dec 13, 2012 3:28 am

Yeah, Repetier drives all the outputs with "software" PWM.
Not sure what the frequency for extruder heater is, but for fans it's something like 5-10 Hz.

Marlin doesn't drive the heater with hardware PWM either, i think.
At least judging by the frequency of the blinking i see.
orcinus
 
Posts: 720
Joined: Tue Feb 14, 2012 4:03 am

Previous

Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests

cron