buildlog.net

Is it possible to get you to post your configuration of hardware and software that you use for 3D printing? It would be nice to have a baseline of what really does work in this environment of 10,000 different types of machines and 25,000 different types of software used. I just have to get a bigger computer to map this to a working environment. I think that I will use one of my Raspberry Pi's for this. Just kidding.

Bob Teeter

I'll see what I can do when I return home. There are a lot of configurations to deal with. Repetier Firmware, Repetier Host and Slic3r all have configurations. I maintain about a two dozen Sllic3r configs for fill percentages, etc.