buildlog.net

John can I buy the extruded and hot end off your ordbot at the show?

Also what is different on the laser vs the x2 Bart made?

Jeremy finished one of the TiEnd Titanium Hot Ends late last night. I am trying to arrange a pick it up to show it at MRRF.

#MRRF was great. It totally exceeded all my expectations. SeeMeCNC did a great job hosting the event. There were printers all over the place. They tried to set a world record for printers running in the same room.

I talked with Josef Prusa a lot. I went to lunch with him, Johnny from Ultimachine and Zach from Inventables. There were many buildlog forum people at the event too. Everyone was very cool. I got all the "titans" of RepRap to sign my RepRap long board.

We are trying to get Prusa to visit PS1 this week before he flies home.

I brought my Delta. I did not plan to print with it because I had not reserved a table. I found a spot later in the day and popped off a few prints before my laptop battery died. There were a ton of Deltas there and I got some tips on using Kiss and Cura. Everyone kept commenting on how clean my delta looks. All I see are the imperfections They scolded for being too anal about it .

Me, explaining how a 3D printer works to Mr. Prusa

http://www.flickr.com/photos/kwixson/85 ... 3032127182