Slic3r 0.9.9 Is Out

General discussion of 3D printers

Re: Slic3r 0.9.9 Is Out

Postby SystemsGuy » Mon Apr 08, 2013 8:13 am

slic3r-delete.png (23.45 KiB) Viewed 7143 times

LOL - :ugeek:

tmccafferty wrote:Where are the configuration files (the ones you change) stored? I have some on the list I want to delete but don't see how to do it. I searched my HD for the configuration name but came up empty.
Posts: 250
Joined: Sat Dec 29, 2012 7:44 am

Re: Slic3r 0.9.9 Is Out

Postby tmccafferty » Mon Apr 08, 2013 2:33 pm

Duhhhh... Surely it can't be that easy!

Thanks :roll:
Posts: 131
Joined: Mon Jan 07, 2013 3:40 pm

Re: Slic3r 0.9.9 Is Out

Postby orcinus » Mon Apr 08, 2013 5:38 pm

bdring wrote:I tend to use KISS more now, but I gave money to Slic3r because it is free. Funny how that works.
They both have different reasons to use them, but Slic3r is definitely on a faster dev cycle.

Make sure to check the KISS forum often.
The 1.1 RC went through quite a few iterations, AFAIK. The dev cycle isn't faster than Slic3r by any means, but it's not as slow as "official" downloads might make you believe.

Re: Cura - didn't like it due to lack of settings. Not sure if it's still like that. Also, it was making some weird jittery moves.
Haven't tested Slic3r 0.9.9, but out of the bunch, KISS has the best support structure generation, IMHO. The most configurable one too.
Posts: 720
Joined: Tue Feb 14, 2012 4:03 am

Re: Slic3r 0.9.9 Is Out

Postby Wired1 » Tue Apr 23, 2013 3:50 am

Seems to run the same as 0.9.8 . I copied it into the existing directory and it uses the config files I had used for the old version so an easy upgrade.
Redwood Valley, Nelson, New Zealand
Open beam Prism blog ~ Thingiverse ~ YouTube ~ Printer webcam
Posts: 10
Joined: Thu Apr 18, 2013 5:32 am


Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 2 guests