Page 1 of 1

Creator software

PostPosted: Mon Apr 29, 2013 3:55 am
by tmccafferty
Anybody tried out the Creator software from Makergear. I was wondering if it was better than the existing free stuff.

Re: Creator software

PostPosted: Wed May 01, 2013 2:37 pm
by tmccafferty
Hmm, maybe I should be the first to try it

Re: Creator software

PostPosted: Wed May 01, 2013 3:02 pm
by Gadroc
I would be very interested as well. I really like looks and the integrated workflow, but gambling withe $150 on the actual slicer piece is a bit much.

Re: Creator software

PostPosted: Wed May 01, 2013 10:41 pm
by liqdfire
I have it and it works pretty well.

It slices a ton faster than slic3r, and does a very good with duplicating the geometry. I have not tried printing stuff that needs supports yet, but I hear that works great.

Re: Creator software

PostPosted: Thu May 02, 2013 1:31 am
by Gadroc
How does the output compare to KISSlicer?

Re: Creator software

PostPosted: Thu May 02, 2013 2:47 am
by orcinus
I'm very curious to know how its support generation compares to KISSlicer's.
So far, KISS is the only slicer that's been making useful/usable support structures for me.

It takes a bit of tweaking, but that's exactly the thing - it has the most configurable support generation of the bunch.

Re: Creator software

PostPosted: Fri May 03, 2013 2:53 am
by liqdfire
I personally never uses KISSlicer, but I have heard others says it is nicer.