Makergear M2
Posted: Mon May 13, 2013 5:12 am
Has anyone been around a Makergear M2 to know how it's print quality and performance stack up against others? Is it hacker friendly or a closed design like Makerbot?
BenJackson wrote:That connector was not designed to be used the way it is...If it melts it's probably due to being backed partway out.
BenJackson wrote:If you drive the bed from 24V you're going to blow the polyfuse (you'll double the amperage). I don't know if the FET on RAMBO can handle it (I replaced the one on my RAMPS and used an external fuse when I did something similar to my prusa)