Temp Sensor Defects...
Posted: Thu Jul 25, 2013 10:57 pm
Hi all you wonderfully experienced folks,
I have a puzzle I'm trying to figure out - I keep getting Temp sensor Defect errors whenever I try to set a temperature.
Here's the setup:
RUMBA board with Budaschnozzle hot end and MK1 heated bed (with standard thermoresistor). All four connections are going where they should be and I've tested for continuity.
In Repetier Firmware, I have the extruder 0 thermocouple setting set for "7" which should be Buddaschnozzle.
The error I get when trying to do anything temperature related (i.e. preheat) is:
extruder 0: temp sensor defect
heated bed: temp sensor defect
Printer set into dry run mode until restart!
When I check temperatures (M105), I get:
T:1081.25 B:-50.88 @:0
I'm really hoping that that info can help diagnose the issue.
Any help, advice, or testing steps would be greatly appreciated!
I have a puzzle I'm trying to figure out - I keep getting Temp sensor Defect errors whenever I try to set a temperature.
Here's the setup:
RUMBA board with Budaschnozzle hot end and MK1 heated bed (with standard thermoresistor). All four connections are going where they should be and I've tested for continuity.
In Repetier Firmware, I have the extruder 0 thermocouple setting set for "7" which should be Buddaschnozzle.
The error I get when trying to do anything temperature related (i.e. preheat) is:
extruder 0: temp sensor defect
heated bed: temp sensor defect
Printer set into dry run mode until restart!
When I check temperatures (M105), I get:
T:1081.25 B:-50.88 @:0
I'm really hoping that that info can help diagnose the issue.
Any help, advice, or testing steps would be greatly appreciated!