k type thermocouple setting
Posted: Thu Aug 01, 2013 1:34 pm
I am trying to use a Chinese made extruder with a K type thermocouple on my X3 board from Panucatt and cannot find a Marlin/Arduino setting that matches the sensor. I have tried all temperature sensor presets on config h and none work. Temperature readings are either way to high (up to 900deg) or to low. What to do? The sensor is described as follows:
K-type thermocouple (PT100 reference temperature of 0 degrees)
K-type thermocouple (PT100 reference temperature of 0 degrees)