Ninja Flex TPE Filmament + EZStruder issues

General discussion of 3D printers

Ninja Flex TPE Filmament + EZStruder issues

Postby Panopticon » Sat Jan 25, 2014 10:09 pm

Has anyone successfully ran and printed with 1.75mm Ninja Flex TPE filament through their SeeMeCNC EZstruder? I'm using a Printrbot J-head, but the EZstruder drive cant push the TPE filament through the nozzle, it just ends up slipping outside of the hobbed gear eventually jamming the extruder drive. The furthest I've gotten is where the filament will reach the top of the J-head but the filament is not stiff enough for the drive to down.

Any thoughts??

:x
Panopticon
 
Posts: 42
Joined: Tue May 07, 2013 1:40 am

Re: Ninja Flex TPE Filmament + EZStruder issues

Postby Panopticon » Wed Jan 29, 2014 3:33 pm

For anyone interested, I've extended the discussion on the SeeMeCNC forums about TPE Filaments + EZtruders.

http://forum.seemecnc.com/viewtopic.php ... 905#p27905
Panopticon
 
Posts: 42
Joined: Tue May 07, 2013 1:40 am


Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron