Launching Prusa i3 Kit @599 USD
Posted: Thu Nov 06, 2014 11:43 amThis kit contains all the required parts to build a complete Prusa i3 machine.It is much easier to assemble than the original Prusa i3
Features :
- Based on the Prusa i3 design
- More easier to assemble than the original Prusa i3
- Smart LCD Control Support
- Prints with both PLA and ABS
Technical Specifications :
1) Build Volume : ( 214 x 214 x 165) mm
2) No. of Extruders : 1
3) Layer Thickness : 0.1 mm - 0.3 mm (This is optimal,but you can go below that)
4) XY Positioning Precision : 0.0125 mm
5) Nozzle Diameter : 0.4mm
6) Filament Diameter : 1.75 mm
7) Power Supply : Input 230 V / Output 12V DC 240 W
8) Electronics : PrintrBoard REV D ( 4 Layer Board)
9) HotEnd : J head HotEnd with Catridge heater, 230C MAX Temperature
10) HeatBed: MK2 HeatBed, 110C MAX Temperature
11) Printing Material : Both PLA and ABS.
12) Build Material : Uses high quality laser cut 6mm acrylic
13) Motors :NEMA17 Stepper motors,1.8 step angle (4.4 kg/cm torque)
14) Connectivity : USB,Micro SDCard using LCD Controller
15) Kit Weight : 8 Kg
You can check out the Printer at http://makemendel.com/3d-printer/prusa-i3-kit
Here is the First look of the Printer
Features :
- Based on the Prusa i3 design
- More easier to assemble than the original Prusa i3
- Smart LCD Control Support
- Prints with both PLA and ABS
Technical Specifications :
1) Build Volume : ( 214 x 214 x 165) mm
2) No. of Extruders : 1
3) Layer Thickness : 0.1 mm - 0.3 mm (This is optimal,but you can go below that)
4) XY Positioning Precision : 0.0125 mm
5) Nozzle Diameter : 0.4mm
6) Filament Diameter : 1.75 mm
7) Power Supply : Input 230 V / Output 12V DC 240 W
8) Electronics : PrintrBoard REV D ( 4 Layer Board)
9) HotEnd : J head HotEnd with Catridge heater, 230C MAX Temperature
10) HeatBed: MK2 HeatBed, 110C MAX Temperature
11) Printing Material : Both PLA and ABS.
12) Build Material : Uses high quality laser cut 6mm acrylic
13) Motors :NEMA17 Stepper motors,1.8 step angle (4.4 kg/cm torque)
14) Connectivity : USB,Micro SDCard using LCD Controller
15) Kit Weight : 8 Kg
You can check out the Printer at http://makemendel.com/3d-printer/prusa-i3-kit
Here is the First look of the Printer