Laser build video and other questions

Questions, Suggestions, Tips, Etc

Laser build video and other questions

Postby Tfdpaintball » Sat Jun 14, 2014 3:06 pm

Hey all,

New here
1.I am considering a build for this laser. I have seen some videos by tim Weir (sorry if spelling is off) about the Vrails and a few others but is there a "from the ground up" resource showing each phase of the build anywhere? I have read through the instructions a few times, but a visual how to would be immensely helpful

I am also curious if anyone who has built the laser to fully incorporate the z axis has had the opportunity to work on etching any anodized aluminum paintball gun bodies. Can Mach 3 handle surfaces like that? This would be the main application I am looking into at the moment.
This would be a small example of the paintball bodies that I would be attempting to mark.
Posts: 1
Joined: Wed Jun 11, 2014 9:54 pm

Re: Laser build video and other questions

Postby TLHarrell » Mon Jun 16, 2014 4:38 am

I've seen others marking paintball gun bodies. Pretty sure they're just shooting the artwork flat on them and not following the shape. I'd recommend trying that with a 5" focal lens.
40w Full Spectrum Engineering 5th Gen Hobby 20"x12" w/ Rotary Engraver
South San Francisco Bay Area - Sales and Support Representative for Full Spectrum Engineering
408-47-LASER - Skype: whitelightlaser-thomas - Facebook: White Light Laser
Posts: 419
Joined: Thu Jul 28, 2011 11:30 pm
Location: Morgan Hill, CA

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 1 guest