Re: Troubleshooting

Hey,
thank you very much! 1/128 should give just about 1 um /pulse with my setting which should work for the x7. But 200 mm / s is not very fast
I hope i can live with that. One thing that is really strange: My engravings are pretty good without any problems but the cutting is that bad. I
will give it a try. Which drivers did you buy? i currently use the m415c
thanks again,
tm
P.S: Kees has the ultimate laser machine ; )
thank you very much! 1/128 should give just about 1 um /pulse with my setting which should work for the x7. But 200 mm / s is not very fast

I hope i can live with that. One thing that is really strange: My engravings are pretty good without any problems but the cutting is that bad. I
will give it a try. Which drivers did you buy? i currently use the m415c
thanks again,
tm
P.S: Kees has the ultimate laser machine ; )