How does the belt connect to the lens carriage?

Questions, Suggestions, Tips, Etc

How does the belt connect to the lens carriage?

Postby bdring » Tue Mar 08, 2011 11:09 pm

Are there any photos or drawings of the underside of the laser carriage where the belt is joined? I can't quite figure out this detail and can't see any references to it in the drawings.

Thanks,

Matt.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: How does the belt connect to the lens carriage?

Postby bdring » Tue Mar 08, 2011 11:17 pm

The belt runs through the t shaped slots in the plate. The belt goes through the long leg of the T. Then a screw is used in the rounded end of the short leg of the T to clamp it to the plate. It does not need to be very tight because the teeth on the belt catch on the head of the screw. Tension on the belt is created by moving the idler bracket. The Y axis works the same on both ends.


x_belt3.JPG


x_belt.JPG

x_belt2.JPG


FYI: These sheet metal parts are all laser cut...not by me though.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: How does the belt connect to the lens carriage?

Postby mt_harrison » Tue Mar 08, 2011 11:26 pm

Could not be clearer, thanks! Perhaps a metal cutting machine for the next project, hey :D ?
mt_harrison
 
Posts: 7
Joined: Thu Mar 03, 2011 8:28 am


Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 6 guests

cron