Orientation of frame and extra tnut table in instructions

Questions, Suggestions, Tips, Etc

Orientation of frame and extra tnut table in instructions

Postby BenJackson » Sun May 22, 2011 7:29 am

(The accompanying image is looking from the rear left corner of the frame toward the front right corner. Front, Left, Right, and Rear are stated as if looking/working from the front of the machine.)


And also:

(Right, rear, etc are stated as if looking at the piece, after installation, from the front.)


I stared at this a good long time when I started assembling the frame and convinced myself that the left/right of the orientations in the table are relative to the image which is (as stated) from the rear. You can see that right away on frame piece 1a which calls for 2 extra nuts on the "right" (which, from the front of the machine, would put them on the inside). It calls for 0 on the "left" which would be where the skins attach. Similarly the right side 2b calls for nuts on the left rather than the right.

Still too soon to know if any of the counts are wrong... ;-)
BenJackson
 
Posts: 522
Joined: Fri Apr 15, 2011 6:13 pm

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 25 guests

cron