bdring wrote:I need some input on changes to the skins. I want to make the skins universal for all control options.
I want to redo the standard controls so they fit in the same cutout as the DSP control panel. This would be a black acrylic plate that glues into the same hole. I think you could probably pop it off if super glue was used and you wanted to change the control method. Otherwise it is only one panel that would need to change.
I plan on moving the e-stop switch to the front of the machine in a hole cut in the skin. I know a lot of people using DSP don't use an e-stop, but they should. The other panel would just have the remaining items.
I want to incorporate a current meter, but I would like feedback on what type is used and where to locate it. I prefer analog, but will bow to the consensus (not a vote...a consensus ). I would like to limit the length of the wiring, so near the back is preferred. I, and others prefer a nice clean, flush top if possible. A nice viewing angle would be nice, but I do not want any special machining required.
bdring wrote:Pot/Pwm Switch. I have been using my 4 axis board which does not have one. It was on twehr's wish list, but I do not think he uses it either.
Users browsing this forum: No registered users and 14 guests