CNC Router
6 posts
• Page 1 of 1
CNC Router
by Woodie49 » Fri Mar 02, 2012 1:50 am
Hi,Has anyone done or is doing a build log on a MakerSlide Router 
- Woodie49
- Posts: 8
- Joined: Wed Mar 16, 2011 4:53 pm
Re: CNC Router
by Woodie49 » Sun Mar 04, 2012 7:36 pm
Woodie49 wrote:Hi,Has anyone done or is doing a build log on a MakerSlide Router
So no one is building a CNC Router useing MakerSlide?
- Woodie49
- Posts: 8
- Joined: Wed Mar 16, 2011 4:53 pm
Re: CNC Router
by Improbable Construct » Sun Mar 04, 2012 7:56 pm
Ha! I just logged in to post the same link as Enraged
ShapeOko just released a batch of the routers and they sold out in under 2 hours.
He plans on doing another batch if this one goes smooth.
ShapeOko just released a batch of the routers and they sold out in under 2 hours.
He plans on doing another batch if this one goes smooth.
- Improbable Construct
- Posts: 57
- Joined: Wed Feb 15, 2012 1:27 am
Re: CNC Router
by gene » Mon Mar 05, 2012 1:49 am
It's tough to go bigger than that due to flex of the extrusion. I think the limit is a 20"x20" working area with the shapeokyo type system. There was talk of a beefier excursion rail in the future so larger scale machines could be done
- gene
- Posts: 55
- Joined: Thu May 05, 2011 4:20 pm
- Location: Louisville, KY
6 posts
• Page 1 of 1
Return to MakerSlide General Discussion
Who is online
Users browsing this forum: No registered users and 7 guests