Colour palette in Corel to suit LaserCAD

I have a LO DSP on order but have not received it as yet. Been playing around with LaserCAD together with X5.
Looks like there are some basic colours that LaserCAD uses to differentiate objects to cut and or engrave.
Perhaps it would be good to have a custom colour palette in X5 to match LaserCAD. Does this sound reasonable?
Is there a way to identify the LaserCAD colours apart from simply visual ? Is there RGB values to use ?
Or am I barking up the wrong tree and not realise it, because so far I have not used the software in earnest ?
Greolt
Looks like there are some basic colours that LaserCAD uses to differentiate objects to cut and or engrave.
Perhaps it would be good to have a custom colour palette in X5 to match LaserCAD. Does this sound reasonable?
Is there a way to identify the LaserCAD colours apart from simply visual ? Is there RGB values to use ?
Or am I barking up the wrong tree and not realise it, because so far I have not used the software in earnest ?
Greolt