DSP and 4 Axis Arduino Shield

Discussions and help on this commercial controller.

Moderator: twehr

DSP and 4 Axis Arduino Shield

Postby baz » Thu Nov 15, 2012 10:37 pm

Unfortunately this post is going to be a bit hasty, I will update it and add more detail/pics tomorrow when I have some more time.

Back ground info; I have just received the LO DSP for my laser. I have a ShapeOko controlled by the TB6560 driver board and Mach3. I have a buildlog.net stepper shield (ejs’ version). I have 8 pololu drivers (not all for this project!)

I need to figure out a way for my DSP to drive the steppers, preferably without buying any more kit. My initial idea was to get an arduino prototype screw shield, sit the driver shield (with accompanying polou’s) on top and have the dsp control the pololu’s directly through the screw interface of the shield (no arduino present). I then saw this http://www.buildlog.net/wiki/doku.php?id=lo_dsp:4axis, it refers to a Schmitt trigger. (I don’t even know what a Schmitt trigger is :o )
So to get to my question, would my idea be possible? Or would I need a custom board like the 4 axis driver? Or could I add some parts onto some perf board to go alongside my driver shield?
Or…is this whole idea any good all together :?:

Thanks in advance, will add some pics and more info soon.


Regards

Baz
ShapeOko #676, eShapeOko #11, 2.x Laser, ORD Bot Hadron
MakerSlide Europe Store
baz
 
Posts: 35
Joined: Tue May 01, 2012 6:52 pm
Location: Yorkshire, United Kingdom

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 1 guest