Page 1 of 1


PostPosted: Mon Nov 02, 2015 1:11 pm
by jamese

Does anyone have any tips for setting up the 708Lite from Sinjoe?
I am making progress but having issues with setting up my 'home' position. Which I feel is best as 'back-left'.
As this gives room to load material etc. As opposed to the zero co ordinates which i feel should be front left
as that helps in drawing designs with the origin point being x=0 y=0.
The sinjoe manual is not exactly helpful in this initial setup.

Thanks all


Re: AWC708Lite

PostPosted: Mon Nov 02, 2015 10:34 pm
by Techgraphix
My homepoint is up-right but it doesn't matter wher you want your homepoint to be.
In LaserCad you can set where you want to home.. Options>System-Options>Work Space>Machine Zero... Set this to the position you like.