DSP Commercial Controller Support
Moderator: twehr
Re: DSP Commercial Controller Support
by lasersafe1 » Tue Jan 29, 2013 3:24 pm
That's why its called "support". Can you do us a favor? You changed two things at once to fix the problem. Can you back out and tell us if it was one or the other? I suspect it was the falling edge problem, but since you also changed acceleration, I don't know for sure.
- lasersafe1
- Posts: 599
- Joined: Fri Nov 27, 2009 8:23 pm
Re: DSP Commercial Controller Support
by jkarpy » Wed Jan 30, 2013 2:51 am
lasersafe1 wrote:That's why its called "support". Can you do us a favor? You changed two things at once to fix the problem. Can you back out and tell us if it was one or the other? I suspect it was the falling edge problem, but since you also changed acceleration, I don't know for sure.
I will back up to my previous settings and test when I am running that same sheet tomorrow. I will post my results.
- jkarpy
- Posts: 10
- Joined: Thu Apr 19, 2012 6:06 pm
- Location: Orlando
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Who is online
Users browsing this forum: No registered users and 13 guests