User Manual For DSP Main Board
Moderator: twehr
4 posts
• Page 1 of 1
User Manual For DSP Main Board
by bdring » Sat Jul 16, 2011 11:28 am
Attached is the most recent version of the user manual for the electronics.
- Attachments
-
User manual of mainboard_v1.12.pdf- Thunderlaser manual
- (633.67 KiB) Downloaded 1303 times
Bart
"If you didn't build it, you will never own it."
"If you didn't build it, you will never own it."
- bdring
- Site Admin
- Posts: 2966
- Joined: Sun Nov 22, 2009 7:33 pm
- Location: Chicago, IL, USA
Re: User Manual For DSP Main Board
by J45on » Sat Jul 16, 2011 5:08 pm
Thanks Bart
On page 6 and 7 it shows different motor driver wiring
Which one should I use and what is the difference ?
On page 6 and 7 it shows different motor driver wiring
Which one should I use and what is the difference ?
- J45on
- Posts: 258
- Joined: Thu Mar 31, 2011 11:30 am
- Location: Kent,united kingdom
Re: User Manual For DSP Main Board
by bdring » Sat Jul 16, 2011 6:08 pm
I believe that is correct. It determines whether your pulse goes from low to high or high to low. I think you use the one on the top of page 6.
Bart
"If you didn't build it, you will never own it."
"If you didn't build it, you will never own it."
- bdring
- Site Admin
- Posts: 2966
- Joined: Sun Nov 22, 2009 7:33 pm
- Location: Chicago, IL, USA
Re: User Manual For DSP Main Board
by twehr » Mon Jul 18, 2011 12:15 pm
bdring wrote:I believe that is correct. It determines whether your pulse goes from low to high or high to low. I think you use the one on the top of page 6.
Correct. Top of page should be correct.
tim
--
"The answer is usually easy and obvious once you know what it is." tw
DIYLaser Blog
SemiHomemadeTools.com
--
"The answer is usually easy and obvious once you know what it is." tw
DIYLaser Blog
SemiHomemadeTools.com
- twehr
- Posts: 439
- Joined: Mon May 24, 2010 4:49 pm
4 posts
• Page 1 of 1
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Who is online
Users browsing this forum: No registered users and 4 guests