Page 2 of 2


PostPosted: Fri Mar 23, 2012 3:24 am
by bdring
Here is the MK7 adapter. It is a piece of heat treated 6061-T6 aluminum with two PEM studs. There are two extra holes in case you want to customize it. The studs are #4-40 because the M3 are harder to get in a short time, but I will supply the nuts.



Jeremy was kind enough to test it.

8-) Jeremy is a one man PR machine. He set one up for a potencial NBC news story and is taking it on the road to a few eastern HackerSpaces.

Re: MK7

PostPosted: Fri Mar 23, 2012 3:29 am
by JeremyBP
The new MK7 plate is really very slick. The extruder mounts by the thermal barrier, and so eliminated having another bolt holding it in place (the bolt wasn't needed, IMO).
It's very flat, and very clean. Which is what I expected from Bart, as everything he designs is clean.