Re: 1.75mm or 3mm filament and nozzle size?
Posted: Thu Mar 01, 2012 4:02 pm
Awesome work Gijs.. I think that will work great!! I also agree with your assessment of legs off the top extruder mount plate there, it would be too flimsy so they are right where they should be with your new adapter.
I wonder if a Wades type extruder could mount to it with it facing that way though? I think on a Wades the motor is mounted sideways (perpendicular to the extruder housing) so it might stick out (Y axis ways) or run up against the back plate of the carriage. Can you check paste one in so we can see the clearance? Thanks!!
From what I'm reading on various reprap sites, a large percentage of folks will be using a Wades (variant) extruder.. I'm also reading a lot of good things about the NEW Budashnoz...
I wonder if a Wades type extruder could mount to it with it facing that way though? I think on a Wades the motor is mounted sideways (perpendicular to the extruder housing) so it might stick out (Y axis ways) or run up against the back plate of the carriage. Can you check paste one in so we can see the clearance? Thanks!!
From what I'm reading on various reprap sites, a large percentage of folks will be using a Wades (variant) extruder.. I'm also reading a lot of good things about the NEW Budashnoz...