ord bot hadron extruders
3 posts
• Page 1 of 1
ord bot hadron extruders
by keos » Mon Oct 29, 2012 5:24 am
where are the extruder fans pluged into on the ramps board
- keos
- Posts: 160
- Joined: Fri Oct 26, 2012 6:58 am
- Location: Granada Hills, California
Re: ord bot hadron extruders
by BingLast » Mon Oct 29, 2012 5:46 am
Thats my question too. Do we run an extra two wires from the extruder gantry?
- BingLast
- Posts: 23
- Joined: Sat Aug 25, 2012 3:49 am
Re: ord bot hadron extruders
by bdring » Mon Oct 29, 2012 12:36 pm
I think most people use "D9" for the fan with RAMPS.
Bart
"If you didn't build it, you will never own it."
"If you didn't build it, you will never own it."
- bdring
- Site Admin
- Posts: 2966
- Joined: Sun Nov 22, 2009 7:33 pm
- Location: Chicago, IL, USA
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 34 guests