Lets see your ORD Bot prints!
Re: Lets see your ORD Bot prints!
by rickmellor » Thu Jun 13, 2013 3:32 pm
Cool, thanks. I'll need to venture into other slicers at some point. I'm not really happy with how Slic3r manages them. I haven't fussed around with them much yet though ... my real hope is to get a second extruder for PLA on this thing before too long.
- rickmellor
- Posts: 89
- Joined: Sat May 04, 2013 4:15 am
- Location: Brooklyn, NY
Re: Lets see your ORD Bot prints!
by orcinus » Thu Jun 13, 2013 4:03 pm
My ultimate goal is a second extruder for PVA 
Now that would make support removal a breeze.
Now that would make support removal a breeze.
- orcinus
- Posts: 720
- Joined: Tue Feb 14, 2012 4:03 am
Re: Lets see your ORD Bot prints!
by rickmellor » Thu Jun 13, 2013 4:10 pm
You have a good source for PVA? The stuff I got from Protoparadigm wasn't cheap. I don't think they even carry it anymore.
- rickmellor
- Posts: 89
- Joined: Sat May 04, 2013 4:15 am
- Location: Brooklyn, NY
Re: Lets see your ORD Bot prints!
by orcinus » Thu Jun 13, 2013 5:38 pm
Nope, at least haven't tried buying any yet (no sense, as i haven't gotten around to fitting two extruders on my ORD Bot yet anyways).
The few European webshops i've found that have it so far, sell it for around 35 EUR for half a kilo, 60 for a kilo.
Expensive, yeah, but it's not something to be used on daily basis anyways, plus, support usually doesn't use up much filament (relative to the printed object).
The few European webshops i've found that have it so far, sell it for around 35 EUR for half a kilo, 60 for a kilo.
Expensive, yeah, but it's not something to be used on daily basis anyways, plus, support usually doesn't use up much filament (relative to the printed object).
- orcinus
- Posts: 720
- Joined: Tue Feb 14, 2012 4:03 am
Who is online
Users browsing this forum: No registered users and 16 guests