Looking for a firmware configuration
Posted: Fri Mar 18, 2016 2:51 am
I'm trying once again to resurrect my Ord Hadron. Replaced a few faulty bits (thermistor, RAMPS board) but no longer have all the notes I made about firmware settings.
It would make things a lot easier for me if someone here could provide a Configuration.h.
Not too fussed about which firmware is used. I'm trying out Repetier at the moment but Marlins seems to be more popular/better.
Configuration is standard except for hotend which is a J-Head (genuine)
Appreciate any assistance here.
Regards
GEoff
It would make things a lot easier for me if someone here could provide a Configuration.h.
Not too fussed about which firmware is used. I'm trying out Repetier at the moment but Marlins seems to be more popular/better.
Configuration is standard except for hotend which is a J-Head (genuine)
Appreciate any assistance here.
Regards
GEoff