mach3 post processor for laser

Anyone care to share a Mach3 Post Processor that will work with Cut2D? Mark's Post Processor doesn't work for some reason. It has my Laser just going in large circles. The Toolpath isn't shown in the Display Window in Mach 3 either.
I have a version that I modified (attachment) that sort of works but the laser stays on after completing a cut and moving on to the next profile. It sort of lingers there with the beam on and I think this is where the Z axis/Safe Z would be happening before a Rapid move. All reference to Z have been removed but I don't know enough about G code, or Post Processors to know what I'm doing....Any help would be appreciated.
I should not that it says Cut3D and I have Cut 2D but I believe this is the original version Bart modified for Cut 2D.
I have a version that I modified (attachment) that sort of works but the laser stays on after completing a cut and moving on to the next profile. It sort of lingers there with the beam on and I think this is where the Z axis/Safe Z would be happening before a Rapid move. All reference to Z have been removed but I don't know enough about G code, or Post Processors to know what I'm doing....Any help would be appreciated.
I should not that it says Cut3D and I have Cut 2D but I believe this is the original version Bart modified for Cut 2D.