Enraged wrote:Turns out my power supply was on its way out, so I picked up one of these 12V 30A supplies that are pretty popular in the reprap community: http://www.ebay.ca/itm/140662404070?ssP ... 1497.l2649
at 30A it should be more than powerful enough for my Hadron, with lots of room for future upgrades like dual extruders and heated beds.
Enraged wrote:I'll probably end up making my own version based on this idea: http://www.thingiverse.com/thing:20129
The power supply is small enough it could probably be mounted to the Hadron as well (the 24V supply for my Shapeoko is similar in size). There are screw holes on all sides for the small computer screws.
naPS wrote:Enraged wrote:Turns out my power supply was on its way out, so I picked up one of these 12V 30A supplies that are pretty popular in the reprap community: http://www.ebay.ca/itm/140662404070?ssP ... 1497.l2649
at 30A it should be more than powerful enough for my Hadron, with lots of room for future upgrades like dual extruders and heated beds.
I have about 30 of the 12v 25A version of those power supplies from Meanwell. It's a very reputable brand, and I've never had an issue with their power supplies. I'll let them go cheap, as I've sold the business I used to use them for. Shoot me a PM if you're interested in one.
Users browsing this forum: No registered users and 19 guests