by bdring » Fri Oct 26, 2012 11:10 pm
It sounds like you have an Arduino and downloaded the software from Arduino. You now need to download, configure and install 3D printer software.
Based on your question it sounds like you are pretty new to things like Arduinos. You might want to just play with the Arduino a while and make it do some things like blink some LEDs, etc. It will get you familiar with the way the whole workflow of loading programs goes. There are a lot of on-line tutorial and the Arduino software comes with examples.
I think you might get very frustrated if you went too fast.
Bart
"If you didn't build it, you will never own it."